Handle Maintenance and Clean

Electromagnetic Shockwave Handle

• Unscrew the rubber sleeve, observe the state of the rubber sleeve, there is wear and tear need to be replaced in a timely manner, remove the working head
• Using the maintenance tool (in the package list), loosen the screws on both sides of this handle(Be careful not to remove the screws completely)
• Remove the spring and the bullet and observe if the spring is deformed(if so, it needs to be replaced)
• Clean the bullet body and working head with a clean towel, and clean the inside of the handle
• Install back in the order of removal

Warm Tips: Be sure to cut off the power or pull out the working handle when operating and cleaning or maintaining the working handle

Pneumatic Shockwave Handle

• Turn the working head the bullet body from the gun counterclockwise to remove
• Unscrew the middle handle and pay attention to the parts(gaskets) of the gun handle falling out

• Pull out the barrel

• Remove the gun handle components

• Clean the disassembled components

• Reinstallation on the original path (pay attention to the direction of the cartridge-the small hole faces inward)

• Add sewing machine oil for lubrication, and finally screw back the working head

Note: Please cut off the power before maintenance to avoid the risk of electric shock and damage to the
machine

(Regular maintenance of the working handle and other accessories can improve its service life, it is recommended to clean once after each use)